European Sealing Association
AVKO AVKOSEAL eC 3 mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: AVKO AVKOSEAL eC 3 mm (/showthread.php?tid=147)



AVKO AVKOSEAL eC 3 mm - AMTEC - 06-06-2020

Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 8/16/2017

Link to gasketdata.org


New data were submitted on 2020-11-20. Compared to the characteristics on gasketdata.org they are a little bit more conservative (except Qmin(L) at tightness class 10^-5 and below.

The poll is re-opened.


RE: AVKO AVKOSEAL eC 3 mm - Teadit - 06-06-2020

Agree to the recommendation of amtec, cross check on PQR because of big tolerance


RE: AVKO AVKOSEAL eC 3 mm - Donit - 06-08-2020

There is big thickness decrease during Qsmax test.
I would seggest also Pqr test at 40 MPa, 230°C to check bore intrusion.

I think that remarks about bore intrusion shall be added whenever they occur.

Maja


RE: AVKO AVKOSEAL eC 3 mm - AVKO - 06-17-2020

I am afraid that this particular product, should be reviewed once again with fresh Datasheet.

The one that we're currently observing does not correlate with the test results.

Asked our QA team to redo all the tests with same parameters. The new Data will be submitted through the regular channels, as it is new material.

Once we've ready Datasheet, same will be published here for review.

Velin


RE: AVKO AVKOSEAL eC 3 mm - SGL - 06-18-2020

I vote no based on the comment of 17th June 8:26 PM of Velin (manufacturer himself).


RE: AVKO AVKOSEAL eC 3 mm - AMTEC - 07-20-2020

AVKO recognized some discrepancies in the characteristics of the datasheet. An new datasheet will be generated, and the poll will be repeated.


RE: AVKO AVKOSEAL eC 3 mm - Donit - 12-01-2020

agree with new data.