European Sealing Association
Eynard Robin - KLINGERtop-chem3210 - 2.0 mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Eynard Robin - KLINGERtop-chem3210 - 2.0 mm (/showthread.php?tid=177)



Eynard Robin - KLINGERtop-chem3210 - 2.0 mm - AMTEC - 02-23-2022

Approval of Data Import from gasketdata.org

Publication Date: 27.05.2015
Link to gasketdata.org

Type: sheet gasket
Material: PTFE


RE: Eynard Robin - KLINGERtop-chem3210 - 2.0 mm - Donit - 02-28-2022

To my opinion second test of EG has strange last value (at room temperature). Somehow it doesn't fit.
Maybe this test should be repeated.


RE: Eynard Robin - KLINGERtop-chem3210 - 2.0 mm - AMTEC - 05-20-2022

Cross-check EG @ RT was recommended.



In the EG test, it was recoignized that during the dwell time and even during the unloading of the gasket creep occured. This behavior led to unrealistic steep (or even negative) slopes of the unlaoding curves, see attached document. We evaluated therefore an area in which the recovery was no longer superimposed by creep.




With this evaluation, the divergence at low gasket stresses was higher than the acceptable one. In the repetition of the cross-check, the results of the first cross-check was confirmed. Eynard Robin agreed to the replacement of their EG/RT results against the results of the two cross-checks.




The results of the cross-checks are attached. The revised datasheet is uploaded in the first post of this thread, it can be accepted in the present form