European Sealing Association
KLINGER A. W. Schultze WaveGuard GR 4.6 mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: KLINGER A. W. Schultze WaveGuard GR 4.6 mm (/showthread.php?tid=235)



KLINGER A. W. Schultze WaveGuard GR 4.6 mm - AMTEC - 04-02-2025

Approval of new Datasheet

Type:       Kammprofile Gasket
Material:   Graphite


Cross-check: We recommend a EG test @RT.


RE: KLINGER A. W. Schultze WaveGuard GR 4.6 mm - SGL - 04-07-2025

As amtec pointed out, at low gasket stresses the leak rate for 40 bar are lower than the ones for 100 bar. Therefore I recommend a leakage test at 100 bar.


RE: KLINGER A. W. Schultze WaveGuard GR 4.6 mm - Frenzelit - 04-08-2025

Agree with SGL - Cross check of leakage test at 100 bar.


RE: KLINGER A. W. Schultze WaveGuard GR 4.6 mm - AMTEC - 05-08-2025

Result of Cross-check

Leakage test @ 100 bar

The cross-check was performed, the leak rates in the cross-check fit to the results of the double test of the manufacturer.

We recommend to published the datasheet in the current version.