![]() |
|
JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS - Printable Version +- European Sealing Association (https://forum.bacibg.org) +-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1) +--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2) +---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10) +---- Thread: JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS (/showthread.php?tid=240) |
JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS - AMTEC - 04-04-2025 Approval of new Datasheet Type: Spiralwound Gasket Material: Graphite Filler The data looks very consistent, and the results of the double tests match very well. Perhaps PQR @ 170 MPa / 200 °C and 400 °C are a bit high. RE: JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS - Donit - 04-07-2025 There are no Pqr tests at 170 MPa. The data are quite logic and acceptable. RE: JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS - SGL - 04-08-2025 I assume amtec ment PQR @ 70 MPa. As it is a new data sheet a cross check is a must, I recommend to perform PQR @ 70 MPa at 400°C as a cross check. RE: JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS - AMTEC - 04-09-2025 Please apologize, we ment 150 MPa / 200 °C and 150 MPa /400 °C. The PQR values are a little bit higher than for QSmax at these temperatures. RE: JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS - Frenzelit - 04-10-2025 we would also recommend PQR at 70 MPa 400°C for cross check. RE: JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS - Klinger - 04-10-2025 Agree with PQR at 70 MPa 400°C for cross check. RE: JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS - AMTEC - 05-08-2025 Result of Cross-check PQR test @ 150 MPa /200 °C: The PQR value was 0.85, which means it is 0.06 below the submitted value and therefore not acceptable. The test was repeated and also this result (0.82) was below the submitted values. We contacted the manufacturer and he agreed that the results of the cross-check should be used on the datasheet. N.B. We also performed a PQR test @ 70 MPa/400 °C. The measured PQR (0.68) was also lower than the submitted values (0.69, 0.74), but still in the acceptable range. |