European Sealing Association
Spetech DRYFLEX NR 800H FG APX2 4.0 mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Spetech DRYFLEX NR 800H FG APX2 4.0 mm (/showthread.php?tid=242)



Spetech DRYFLEX NR 800H FG APX2 4.0 mm - AMTEC - 05-19-2025

Approval of new Datasheet

Type:        Kamprofile Gasket
Material:   Graphite Layer

Cross-check: We recommend a leakage test @ 40 bar.


RE: Spetech DRYFLEX NR 800H FG APX2 4.0 mm - Frenzelit - 05-27-2025

agree with suggestion of amtec Leckage @40 bar


RE: Spetech DRYFLEX NR 800H FG APX2 4.0 mm - Klinger - 06-02-2025

agree with AMTEC


RE: Spetech DRYFLEX NR 800H FG APX2 4.0 mm - AMTEC - 09-01-2025

Result of Cross-check

Leakage test @ 40 bar

The cross-check was performed, the leak rates in the cross-check fit to the results of the double test of the manufacturer, except at the first 3 gasket stress levels. But at these stresses the leak rate is below 0,001 mg/m/s, therefore a divergence factor of 6 is acceptable.

We recommend to published the datasheet in the current version.