![]() |
|
Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - Printable Version +- European Sealing Association (https://forum.bacibg.org) +-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1) +--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2) +---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10) +---- Thread: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm (/showthread.php?tid=82) |
Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - root - 01-06-2020 Approval of Data Import from gasketdata.org Type: sheet gasket Publication: 14.01.2013 Material: GR Link to gasketdata.org RE: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - SGL - 10-05-2020 According to our measurements leakage is far too optimistic. I vote for a leakage cross-check at 40 bar. RE: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - Donit - 10-08-2020 I think thatĀ that Pqr values must be providedĀ at 3 different gasket surface stresses. If you disagree, skeep my vote. RE: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - Klinger - 10-09-2020 Standard requires 3 Pqr values at each temperature RE: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - Teadit - 10-12-2020 Agree for three gasket loads at each temperature RE: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - Flexitallic - 10-16-2020 Since it is a direct import from munster data, not sure if the 3 x stress level rule should applies. RE: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - EynardRobin - 10-19-2020 add PQR values at 3 different temperatures RE: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - AMTEC - 11-10-2020 A cross-check (leakage test) at 40 bar was requested. The result oof the cross-check and comparison with the submitted data is attached in this post. The characteristics provided by Frenzelit are conservative, and therefore accepted. In addition, Frenzelit provided the missing data for the creep relaxation tests. The results fit to the other characteristics sent earlier. Therefore, we suggest that the datasheet can be accepted now. The datasheet is updated and available in the first post of this thread. RE: Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm - Donit - 11-11-2020 Agreed. |