European Sealing Association
Frenzelit novapress UNIVERSAL 2.0mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Frenzelit novapress UNIVERSAL 2.0mm (/showthread.php?tid=87)



Frenzelit novapress UNIVERSAL 2.0mm - root - 01-06-2020

Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 23.04.2015

Material: FA

Link to gasketdata.org


RE: Frenzelit novapress UNIVERSAL 2.0mm - Donit - 10-08-2020

Qsmax test to check Eg values recomended.
Also Pqr values should be added.


RE: Frenzelit novapress UNIVERSAL 2.0mm - Klinger - 10-08-2020

standard requires 3 Pqr at each temperature. datasheet provides only 2.


RE: Frenzelit novapress UNIVERSAL 2.0mm - Teadit - 10-12-2020

Agree, about at least three temperature (each at three loads).


RE: Frenzelit novapress UNIVERSAL 2.0mm - Flexitallic - 10-16-2020

Since it is a direct import from munster data, not sure if the 3 x stress level rule should applies for PQR.


RE: Frenzelit novapress UNIVERSAL 2.0mm - EynardRobin - 10-19-2020

PQR values should be added


RE: Frenzelit novapress UNIVERSAL 2.0mm - AMTEC - 11-10-2020

Frenzelit provided the missing data for the creep relaxation tests. The results fit to the other characteristics sent earlier. Therefore, we suggest that the datasheet can be accepted now.

The datasheet is updated and available in the first post of this thread.


RE: Frenzelit novapress UNIVERSAL 2.0mm - Donit - 11-11-2020

I think that Eg value at 80 MPa for room temperature shall be skipped, as it is possible in accordance with new draft of EN 13555 standard.
Otherwise no objections.


RE: Frenzelit novapress UNIVERSAL 2.0mm - AMTEC - 11-12-2020

(11-11-2020, 01:03 PM)Donit Wrote: I think that Eg value at 80 MPa for room temperature shall be skipped, as it is possible in accordance with new draft of EN 13555 standard.
Otherwise no objections.

Frenzelit agreed to skip this value. In the datasheet for the final approval, it will be removed.