Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
14.29%
1 14.29%
No (Comment in the thread)
28.57%
2 28.57%
Yes, but cross-check is required (Specify kind of test in the thread)
28.57%
2 28.57%
Abstain
28.57%
2 28.57%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Frenzelit novaphit SSTC TA-L with XP Tech 1,6 mm
#1
Thumbs Up 
Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 02.07.2013

Material: GR

Link to gasketdata.org


Attached Files
.pdf   Frenzelit novaphit SSTC TA-L with XP 1,6 mm_ESA Approval_2020-10-03.pdf (Size: 205.44 KB / Downloads: 28)
.pdf   Frenzelit novaphit SSTC TA-L with XP 1,6 mm_ESA Approval_a_2020-11-09.pdf (Size: 670.85 KB / Downloads: 10)
Reply
#2
EG at RT looks a little bit strange
Reply
#3
For Frenzelit novaphit SSTC TA-L with XP 2.0 mm I voted for a leakage cross-check at 40 bar. If this cross-check confirms that the data provided by Frenzelit are within the allowable divergence compared to the cross-check, my vote for the 1.6 mm thick material changes to YES. If the cross-check of the 2.0 mm thick material should show that the allowable divergence is not met, I vote for a leakage cross-check at 40 bar for the 1.6 mm thickness as well.
Reply
#4
Standard requires that Pqr values are measured at 3 different gasket surface stresses.
In this datasheet the Pqr was measured only at two different gasket surface stresses.
Additional data shall be added before publishing.
Reply
#5
Standard requires that Pqr values are measured at 3 different gasket surface stresses.
Reply
#6
Agree for 3 gasket loads at each temperature.
Reply
#7
(10-07-2020, 03:15 PM)Donit Wrote: Standard requires that Pqr values are measured at 3 different gasket surface stresses.
In this datasheet the Pqr was measured only at two different gasket surface stresses.
Additional data shall be added before publishing.

Agree.
Reply
#8
Frenzelit provided the missing data for the creep relaxation tests. The results fit to the other characteristics sent earlier. Therefore, we suggest that the datasheet can be accepted now.

The datasheet is updated and available in the first post of this thread.
Reply
#9
Agreed.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)