Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
0%
0 0%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
83.33%
5 83.33%
Abstain
16.67%
1 16.67%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Klinger KLINGERSIL C 4500 2.0 mm
#1
Thumbs Up 
Approval of Data Import from gaksetdata.org

Publication Date: 03.07.2012
Link to gasketdata.org

Type: Sheet gasket
Material: Fiber


Attached Files
.pdf   Klinger-KLINGERSIL C 4500-2.0 mm_ESA Approval_2021-09-03.pdf (Size: 576.28 KB / Downloads: 7)
Reply
#2
Agree with cross-check recommendation: EG @ 300 °C.
Maja
Reply
#3
Agree with cross-check recommendation EG @ 300 °C of AMTEC and DONIT.
Reply
#4
For me ok as recommended above.
Reply
#5
To me it seems that the numbers in the table responsible for Eg@300C are misplaced and shifted, i.e. I agree with AMTEC recommendation. Perhaps it'll be best to do a cross check.
Reply
#6
We agree with recommended crosscheck
Reply
#7
Cross-check:

EG @ 300°C

Result of Cross-check:
The moduli of elasticity are within the allowable divergence for cross-checks. Only at the first gasket stress level (20 MPa), the value is much higher than the values of the double test. We believe that this value is a result of the test procedure with heating up at a gasket stress level of 20 MPa. Also for othe fiber based sheet materials this effect can be recognized. We suggest to declare this value as an outliner.

Therefore, we recommend that the characteristics as sown on the updated datasheet can be published.


Attached Files
.pdf   Klinger-KLINGERSIL C 4500-2.0 mm_Cross-check_2021-09-03.pdf (Size: 36.06 KB / Downloads: 3)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)