Poll: How shall we treat datasheets for non-standard dimensions?
You do not have permission to vote in this poll.
Statement on datasheet is sufficient.
0%
0 0%
One additional gasket type "non-standard" should be added.
0%
0 0%
For each gasket type a "non-standard" option should be added.
100.00%
5 100.00%
Other, specified in post.
0%
0 0%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"Non-standard" dimensions of test samples
#1
In EN 13555 there are the following dimensions for the test samples defined:



1. DN40/PN40 according EN 1514-1 to EN 1514-7


2. NPS 4 Class 300 according to EN 12560-1 to  EN 12560-7


3. For the use in a tongue and groove, the gasket must fit into the groove of EN 1092-1 or EN 1759-1 unstead of having the geometry of EN 1514 or EN 12560 series


4.For tapes an inner diameter of 110 mm is defined



When determining characteriistics for geometries that differ from the geometries in EN 1514 or EN 12560 series, the datasheets should not be listed in the same category of gasket types, or at least the datasheet should state very clearly that the gasket dimension does not conform to the test standard.



Here are 4 possible solutions:



1. The statement in the header of the datasheet is sufficient, no additional gasket type is required

2. A new gasket type "non-standard" should be added in which all gasket characteristics determined for a different size are published

3. For all gasket types an additional gasket type non-standard should be added (e.g. (Spiralwound gasket - non-standard")

4. Other



For the gaskets used in a tongue and groove, the same question arises. Shall they be listed together with the EN1514 or EN 12560 characteristics, or shall they be listed in one caztegory "Type TG" for all gasket types, or do we need for each gasket type an additional category (e.g. "Type TG - sheet gasket"). There will be a second thread dealing with this question.



Please select one of the options in the poll or share your opinion in a post.
Reply
#2
I am in favour for a non standard dimension.
According my interpretation, the inner diameter of the tape should have 110mm.
Reply
#3
(04-01-2021, 08:19 AM)Teadit Wrote: I am in favour for a non standard dimension.
According my interpretation, the inner diameter of the tape should have 110mm.
Florian, you are right, the inner diameter should have 110 mm. We changed the wording in the post.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)