Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
0%
0 0%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
100.00%
3 100.00%
Abstain
0%
0 0%
Total 3 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Jawa Kammprofile Gasket M302A-M303A-M304A 5.0 mm
#1
Thumbs Up 
Approval of new Datasheet submitted by Jawa Industrie-Dichtungen GmbH (Non-member)



Type: Kammprofile Gasket

Material: GR


Since this is a new datasheet, and the tests were not performed by one of the acknowledged independent test houses, we recommend the following cross-checks:

- PQR@ 30MPa/200 °C
- Leakage test @40 bar

N.B: We realized that some data were not transfered to the evalution file. We added these missing data now.


Attached Files
.pdf   JAWA-Kammprofilgasket TYPE M302A-M303A-M304A-1.4571-316Ti-GR_5.0 mm_Draft.pdf (Size: 1.11 MB / Downloads: 5)
.pdf   JAWA-Kammprofilgasket TYPE M302A-M303A-M304A-1.4571-316Ti-GR_5.0 mm_Draft_a.pdf (Size: 1.15 MB / Downloads: 2)
Reply
#2
I agree with x-checks proposed by AMTEC
Reply
#3
I also agree with the cross-checking proposed by AMTEC.
Reply
#4
I also agree with the cross-checks proposed by AMTEC
Reply
#5
I agree with the cross-checks proposed by AMTEC
Reply
#6
Cross-checks: 

The PQR value at 30 MPa/200 °C in the cross-check was 0,83 which is much better than 0,59 which was submitted by the manufacturer.

The leak rates measured in the cross-check are lower than the ones orivided by the manufacturer (except at first gasket stress level of 10 MPa).

Since the data shown on the datasheet are conservative, we recommend to publish these characteristics.


Attached Files
.pdf   JAWA-Kammprofilgasket TYPE M302A-M303A-M304A-1.4571-316Ti-GR_5.0 mm_Cross-check_2024-02-05.pdf (Size: 227.64 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)