Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
50.00%
3 50.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
16.67%
1 16.67%
Abstain
33.33%
2 33.33%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flexitallic Flexicarb RGS3 1.5 mm
#1
Thumbs Up 
Approval of new Datasheet

Type:         Sheet Gasket
Material:     Graphite

Cross-check: From our point of view, all characteristics are consistent, so we leave it to the TF to determine a cross-check.


Attached Files
.pdf   Flexitallic-Flexicarb RGS 3-1.5mm_ESA Approval_2024-06-20.pdf (Size: 1.14 MB / Downloads: 7)
Reply
#2
PQR at 300°C for 50MPa load is relatively high, if retesting should be needed, I would sugest to either test this value or test QSminL for 25bar using QA=60MPa load

Other comments: QminL to reach L0,01 is relatively high through all line pressures (twice as high than some SGL sheets), however graphite sheet not tested to 400°C???
Reply
#3
I agree with amtec that all characteristics look consistent, the characteristics are also in line with my expectations. Looking at the data, a cross-check is not necessary, but due to our ESAdata specification there has to be a cross-check for every new material. I therefore ask for a cross-check PQR at 300°C and 30 MPa.
Reply
#4
Cross-check:



PQR @ 30MPa/300°C



The PQR value at 30 MPa/200 °C in the cross-check was 0,93 which is within the allowable divergence compare to the value of 0,97 which was submitted by the manufacturer.



Therefore, we recommend to publish the characteristics of this material.


Attached Files
.pdf   Flexitallic-Flexicarb RGS 3-1.5mm_Cross-Check_2024-06-20.pdf (Size: 106.91 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)