Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
14.29%
1 14.29%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
85.71%
6 85.71%
Abstain
0%
0 0%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Teadit TF1570 2.0 mm
#1
Thumbs Up 
Revision of the datasheet published on 25.03.2021:

- adjustment to EN 13555:2021
- some additional PQR values
- new leakage curves at 10 and 40 bar

Recommended cross-check:

Leakage test @ 40 bar


Attached Files
.pdf   Teadit-TF1570-2.0 mm-ESA Approval Rev03_2024-11-11.pdf (Size: 1.06 MB / Downloads: 8)
Reply
#2
There is not any attached file (test report).
Reply
#3
please send notification when new datasheet is online
Reply
#4
Please attach file and start approval process again.
Reply
#5
Agree with AMTEC as far as leakage curves are the new part in the datasheet
Reply
#6
I would go for Pqr cross check test at 30MPa and 150°C.
Then this Pqr value can also be used.
Reply
#7
I'd do both:
Leakage test @ 40 bar
Pqr cross check test at 30MPa and 150°C.
Reply
#8
Agree on cross-check Leakage test @ 40 bar. I would not do the Pqr cross-check, if Teadit would like to publish a third Pqr value then they should test and provide it themselves.
Reply
#9
Agree on cross-check Leakage test 40 bar
Reply
#10
Result of Cross-check:

Leakage test at 40 bar:

The cross-check revealed good agreement of the leakage rate at gasket stresses greater than 20 MPa. For lower gasket stresses, the outliers in the measurement data of Teadit were corrected to higher leakage rates, as permitted by EN 13555.

Teadit agreed to this procedure and use the results of the cross-check for publishing the datasheet.


Attached Files
.pdf   Teadit-TF1570-2.0 mm-Cross-check_2025-06-10.pdf (Size: 196.35 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)