Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
60.00%
3 60.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
20.00%
1 20.00%
Abstain
20.00%
1 20.00%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
GORE® Universal Pipe Gasket 3.0mm
#3
It is recommended to accept the datasheet without a cross-check.

Comment to the other replies of the Task force:

Klinger: The increase of the leak rate at gasket stress levels above 60 MPa is probably caused by too short measuring times. The characteristics are not influenced by this behavior.
Reply


Messages In This Thread
GORE® Universal Pipe Gasket 3.0mm - by root - 01-06-2020, 12:12 AM
RE: GORE® Universal Pipe Gasket 3.0mm - by AMTEC - 09-30-2020, 04:15 PM
RE: GORE® Universal Pipe Gasket 3.0mm - by IDT - 10-01-2020, 08:10 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)