Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
28.57%
2 28.57%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
57.14%
4 57.14%
Abstain
14.29%
1 14.29%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IDT UNIFLUOR FD01 WS 7551 2.0mm
#7
Cross-check EG @ RT was recommended. TF asked for an additional cross-check @ 40 bar.

In the leakage test at 40 bar, the results of IDT´s double test could be confirmed.
In the EG test, the divergence at low gasket stresses was higher than the acceptable one. In the repetition of the cross-check, the results of the first cross-check was confirmed. IDT agreed to the replacement of their EG/RT results against the results of the two cross-checks. As there was one outliner at 80 MPa in one of the two tests, this value was ignored in the evaluation.

The results of the cross-checks are attached. The revised datasheet is uploaded in the first post of this thread, it can be accepted in the present form


Attached Files
.pdf   IDT FD01 UNIFLUOR WS 7551 2,0 mm_Cross-Check_2020-11-05.pdf (Size: 173 KB / Downloads: 0)
Reply


Messages In This Thread
IDT UNIFLUOR FD01 WS 7551 2.0mm - by root - 01-06-2020, 12:12 AM
RE: IDT UNIFLUOR FD01 WS 7551 2.0mm - by SGL - 08-21-2020, 01:31 PM
RE: IDT UNIFLUOR FD01 WS 7551 2.0mm - by Donit - 09-01-2020, 01:47 PM
RE: IDT UNIFLUOR FD01 WS 7551 2.0mm - by Klinger - 09-01-2020, 04:36 PM
RE: IDT UNIFLUOR FD01 WS 7551 2.0mm - by AMTEC - 10-06-2020, 12:22 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)