Poll: How shall we treat datasheets for non-standard dimensions?
You do not have permission to vote in this poll.
Statement on datasheet is sufficient.
0%
0 0%
One additional gasket type "non-standard" should be added.
0%
0 0%
For each gasket type a "non-standard" option should be added.
100.00%
5 100.00%
Other, specified in post.
0%
0 0%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"Non-standard" dimensions of test samples
#3
(04-01-2021, 08:19 AM)Teadit Wrote: I am in favour for a non standard dimension.
According my interpretation, the inner diameter of the tape should have 110mm.
Florian, you are right, the inner diameter should have 110 mm. We changed the wording in the post.
Reply


Messages In This Thread
RE: "Non-standard" dimensions of test samples - by AMTEC - 04-01-2021, 11:02 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)