Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
14.29%
1 14.29%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
85.71%
6 85.71%
Abstain
0%
0 0%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Teadit TF1570 2.0 mm
#10
Result of Cross-check:

Leakage test at 40 bar:

The cross-check revealed good agreement of the leakage rate at gasket stresses greater than 20 MPa. For lower gasket stresses, the outliers in the measurement data of Teadit were corrected to higher leakage rates, as permitted by EN 13555.

Teadit agreed to this procedure and use the results of the cross-check for publishing the datasheet.


Attached Files
.pdf   Teadit-TF1570-2.0 mm-Cross-check_2025-06-10.pdf (Size: 196.35 KB / Downloads: 0)
Reply


Messages In This Thread
Teadit TF1570 2.0 mm - by AMTEC - 11-11-2024, 02:45 PM
RE: Teadit TF1570 2.0 mm - by Montero - 11-12-2024, 12:55 PM
RE: Teadit TF1570 2.0 mm - by Klinger - 11-13-2024, 10:57 PM
RE: Teadit TF1570 2.0 mm - by SGL - 11-18-2024, 11:31 AM
RE: Teadit TF1570 2.0 mm - by Montero - 11-20-2024, 02:25 PM
RE: Teadit TF1570 2.0 mm - by Donit - 11-20-2024, 05:30 PM
RE: Teadit TF1570 2.0 mm - by Klinger - 11-21-2024, 12:18 PM
RE: Teadit TF1570 2.0 mm - by SGL - 11-21-2024, 06:37 PM
RE: Teadit TF1570 2.0 mm - by Frenzelit - 11-28-2024, 12:58 PM
RE: Teadit TF1570 2.0 mm - by AMTEC - 06-10-2025, 12:23 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)