Approval of Data Import from gasketdata.org
Type: spiralwound gasket
Publication: 05/13/16
Material: N/A
Link to gasketdata.org
Type: spiralwound gasket
Publication: 05/13/16
Material: N/A
Link to gasketdata.org
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 3 | 50.00% | |
| No (Comment in the thread) | 0 | 0% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 2 | 33.33% | |
| Abstain | 1 | 16.67% | |
| Total | 6 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Flexitallic Change Flexicarb 316 4.6mm
|
|
Approval of Data Import from gasketdata.org
Type: spiralwound gasket Publication: 05/13/16 Material: N/A Link to gasketdata.org
07-23-2020, 01:26 PM
It is very obviously that metal to metal contact appears at 100MPa (for 400°C).
If this does not matter, I'm fine with data.
07-27-2020, 02:47 PM
PQR and E Modulus have high tolerance. Do not know how to vote and abstain.
08-04-2020, 03:00 PM
11 times in a row the exactly same Eg of 180000 in both tests needs a crosckeck
08-06-2020, 01:23 AM
(08-04-2020, 03:00 PM)Klinger Wrote: 11 times in a row the exactly same Eg of 180000 in both tests needs a crosckeck Totally agree, there's something wrong here. Do not know if a crosscheck is required, but it'll be nice if someone could explain these values, because it is clear that the eg is variing in both tests for all Eg values. Otherwise a crosscheck at 400C for Creep Relaxation would be nice.
10-06-2020, 05:25 PM
Cross-check EG @ 400 °C requested.
Comment/Explanation of amtec: When Flexitallic tested this material in the EG procedure at 400 °C, they measured only a very low recovery (below 2 µm) at higher gasket stresses. Using the equation of EN 13555 for the determination of EG led to values above 200,000 MPa. Because these values are higher than the modulus of elasticity of the metallic core, we recommended Flexitallic to limit the EG values to the modulus of elasticity of the steel material. In fact, the resolution and the accuracy of the measurement chain is worse than the measured recovery. Therefore, we do not see any benefit in a cross-check in this specific test with this material. So we recommend approving these values unless someone has a better idea of how to handle these data.
10-09-2020, 08:55 PM
(10-06-2020, 05:25 PM)AMTEC Wrote: Cross-check EG @ 400 °C requested.ok! |
|
« Next Oldest | Next Newest »
|