Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
16.67%
1 16.67%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
83.33%
5 83.33%
Abstain
0%
0 0%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Teadit TF1570 3.0 mm
#1
Thumbs Up 
Revision of the datasheet published on 01.11.2020:

- adjustment to EN 13555:2021
- new characteristics at 150 °C
- characteristics at 100 °C deleted

Recommended cross-check:

PQR @ 140 MPa/150 °C


Attached Files
.pdf   Teadit-TF1570-3.0 mm-ESA Approval Rev02_2024-11-11.pdf (Size: 1.04 MB / Downloads: 10)
Reply
#2
In test report second page, "Maximum allowable gasket stress QSmax" section, temperatures in the table are 23ºC/100ºC/250ºC.
But the correct one would be 23ºC/150ºC/250ºC, isn´t it?

Agree with AMTEC
Reply
#3
agree with PQR @ 140 MPa/150 °C
Reply
#4
agree with Amtec
Reply
#5
Agree with AMTEC
Reply
#6
(11-12-2024, 12:48 PM)Montero Wrote: In  test report second page, "Maximum allowable gasket stress QSmax" section, temperatures in the table are 23ºC/100ºC/250ºC.
But the correct one would be 23ºC/150ºC/250ºC, isn´t it?

Agree with AMTEC


Yes, 23ºC/150ºC/250ºC is correct.
Reply
#7
Cross-check:

PQR @ 140 MPa/150°C was confirmed.

We recommend to published the datasheet in the current version.


Attached Files
.pdf   Teadit-TF1570-3.0 mm_Cross-check_2025-03-19.pdf (Size: 106.54 KB / Downloads: 1)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)