Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
25.00%
1 25.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
25.00%
1 25.00%
Abstain
50.00%
2 50.00%
Total 4 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KLINGERSIL C 4430plus 2.0 mm
#1
Thumbs Up 
Approval of Data Import from gaksetdata.org

Publication Date: 22.05.2014
Link to gasketdata.org

Type: Sheet gasket
Material: Fiber


Attached Files
.pdf   Klinger-KLINGERSIL C 4430plus-2.0 mm_ESA Approval_2021-10-19.pdf (Size: 653.48 KB / Downloads: 18)
Reply
#2
Agree with suggestion: cross-check: EG @ 300 °C recommended

Maja
Reply
#3
agree with suggestion of amtec for cross check
Reply
#4
Cross-check:
We recommended a cross-check to verify the recovery behavior at 300 °C.

EG @ 300 °C

Result of cross-check:

The moduli of elasticy measured in the cross-check are all withing the allowable divergence for cross-checks. The value at the initial gasket stress level of 20 MPa is declared as an outliner. We believe that this is not a realstic value, it is caused by the heating up at this stress level and the material change during this process.

We recommend to publish the datasheet.


Attached Files
.pdf   Klinger-KLINGERSIL C 4430plus-2.0 mm_Cross-Check_2021-10-19.pdf (Size: 36.07 KB / Downloads: 2)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)