Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
40.00%
2 40.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
60.00%
3 60.00%
Abstain
0%
0 0%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Jawa Corrugated Gasket Typ SW201A 0.8 mm GR 3.0 mm
#1
Thumbs Up 
Approval of new Datasheet submitted by Jawa Industrie-Dichtungen GmbH (Non-member)

Type: Corrugated Gasket

Material: GR

Since this is a new datasheet, and the tests were not performed by one of the acknowledged independent test houses, we recommend the following cross-check:

- EG@ 200 °C

Other suggestions are welcome.


Attached Files
.pdf   JAWA-Corrugated Gasket-1.4571-GR-3.0 mm_ESA Approval 2024-09-02.pdf (Size: 1.03 MB / Downloads: 11)
Reply
#2
Geometry 94x49 is probably a Typo.
No further comments.
Reply
#3
Agree with Amtec ( same with Teadit)
Reply
#4
Agree with all above notes.
Reply
#5
Cross-check:

EG @ 200 °C

The EG values at 200 °C in the cross-check was fit pretty good to the values submitted by the manufacturer. The divergence was within the acceptable limit. Especially at high stresses, the divergence was below 10%.

Therefore, we recommend to publish the characteristics of this material.


Attached Files
.pdf   JAWA-Corrugated Gasket-1.4571-GR-3.0 mm_Cross-Check_2024-09-17.pdf (Size: 172.16 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)