European Sealing Association
Flexitallic Sigma 500 2.0 mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Flexitallic Sigma 500 2.0 mm (/showthread.php?tid=206)



Flexitallic Sigma 500 2.0 mm - AMTEC - 06-20-2024

Approval of new Datasheet
(published on gaskletdata.org before, but new characteristics)

Type:         Sheet Gasket
Material:     PTFE


Cross-check: Due to the discontinuous course we recommend a EG test at RT.


RE: Flexitallic Sigma 500 2.0 mm - Donit - 06-20-2024

Agree with the amtec proposal.

BR, Maja


RE: Flexitallic Sigma 500 2.0 mm - Montero - 06-21-2024

I agree with Maja and AMTEC proposal too.


RE: Flexitallic Sigma 500 2.0 mm - SGL - 06-21-2024

Agree with the amtec proposal.


RE: Flexitallic Sigma 500 2.0 mm - Klinger - 06-26-2024

Agree with above


RE: Flexitallic Sigma 500 2.0 mm - AVKO - 06-27-2024

Agree with AMTEC, however the surrounding values are very close, so it is either the material, or the rig.
Perhaps a cross-check will give the same results. Just speculating


RE: Flexitallic Sigma 500 2.0 mm - Teadit - 06-28-2024

Do not see requirement to double check the EG values. Looks good in my opinion.
Would go for either PQR 190MPa at 150°C or 100MPa at 250°C. Qsmax looks high for me at this harsh conditions.
Best Regards
Florian


RE: Flexitallic Sigma 500 2.0 mm - AMTEC - 07-15-2024

Cross-check:



PQR @ 190MPa/150°C



The PQR value at 190 MPa/150 °C in the cross-check was 0,83 which is within the allowable divergence compared to the value of 0,87 which was submitted by the manufacturer.



Therefore, we recommend to publish the characteristics of this material.