Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
0%
0 0%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
100.00%
7 100.00%
Abstain
0%
0 0%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flexitallic Sigma 500 2.0 mm
#1
Thumbs Up 
Approval of new Datasheet
(published on gaskletdata.org before, but new characteristics)

Type:         Sheet Gasket
Material:     PTFE


Cross-check: Due to the discontinuous course we recommend a EG test at RT.


Attached Files
.pdf   Flexitallic-Sigma 500-2.0mm_ESA Approval_2024-06-20.pdf (Size: 1.2 MB / Downloads: 12)
Reply
#2
Agree with the amtec proposal.

BR, Maja
Reply
#3
I agree with Maja and AMTEC proposal too.
Reply
#4
Agree with the amtec proposal.
Reply
#5
Agree with above
Reply
#6
Agree with AMTEC, however the surrounding values are very close, so it is either the material, or the rig.
Perhaps a cross-check will give the same results. Just speculating
Reply
#7
Do not see requirement to double check the EG values. Looks good in my opinion.
Would go for either PQR 190MPa at 150°C or 100MPa at 250°C. Qsmax looks high for me at this harsh conditions.
Best Regards
Florian
Reply
#8
Cross-check:



PQR @ 190MPa/150°C



The PQR value at 190 MPa/150 °C in the cross-check was 0,83 which is within the allowable divergence compared to the value of 0,87 which was submitted by the manufacturer.



Therefore, we recommend to publish the characteristics of this material.


Attached Files
.pdf   Flexitallic-Sigma 500-2.0mm_Cross-Check_2024-07-18.pdf (Size: 107.88 KB / Downloads: 2)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)