Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
20.00%
1 20.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
80.00%
4 80.00%
Abstain
0%
0 0%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
JAWA Spiralwound Gasket Type S602 SS/SS/GR/CS
#1
Thumbs Up 
Approval of new Datasheet

Type: Spiralwound Gasket
Material: Graphite Filler

The data looks very consistent, and the results of the double tests match very well. Perhaps PQR @ 170 MPa / 200 °C and 400 °C are a bit high.


Attached Files
.pdf   JAWA-Spiralwound gasket TYPE S602-SS-SS-GR-CS-4.5 mm_ESA Approval_2025-04-05.pdf (Size: 1,017.65 KB / Downloads: 13)
Reply
#2
There are no Pqr tests at 170 MPa.
The data are quite logic and acceptable.
Reply
#3
I assume amtec ment PQR @ 70 MPa. As it is a new data sheet a cross check is a must, I recommend to perform PQR @ 70 MPa at 400°C as a cross check.
Reply
#4
Please apologize, we ment 150 MPa / 200 °C and 150 MPa /400 °C. The PQR values are a little bit higher than for QSmax at these temperatures.
Reply
#5
we would also recommend PQR at 70 MPa 400°C for cross check.
Reply
#6
Agree with PQR at 70 MPa 400°C for cross check.
Reply
#7
Result of Cross-check

PQR test @ 150 MPa /200 °C:

The PQR value was 0.85, which means it is 0.06 below the submitted value and therefore not acceptable. The test was repeated and also this result (0.82) was below the submitted values.

We contacted the manufacturer and he agreed that the results of the cross-check should be used on the datasheet.

N.B. We also performed a PQR test @ 70 MPa/400 °C. The measured PQR (0.68) was also lower than the submitted values (0.69, 0.74), but still in the acceptable range.


Attached Files
.pdf   JAWA-Spiralwound gasket TYPE S602-SS-SS-GR-CS-4.5 mm_Cross-Check_2025_04-29.pdf (Size: 128.31 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)