Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
66.67%
2 66.67%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
33.33%
1 33.33%
Abstain
0%
0 0%
Total 3 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Spetech DRYFLEX NR 800H FG APX2 4.0 mm
#1
Thumbs Up 
Approval of new Datasheet

Type:        Kamprofile Gasket
Material:   Graphite Layer

Cross-check: We recommend a leakage test @ 40 bar.


Attached Files
.pdf   Spetech-DRYFLEX NR 800H FG APX2-4.0 mm_ESA Approval_2025-05-19.pdf (Size: 1.29 MB / Downloads: 7)
Reply
#2
agree with suggestion of amtec Leckage @40 bar
Reply
#3
agree with AMTEC
Reply
#4
Result of Cross-check

Leakage test @ 40 bar

The cross-check was performed, the leak rates in the cross-check fit to the results of the double test of the manufacturer, except at the first 3 gasket stress levels. But at these stresses the leak rate is below 0,001 mg/m/s, therefore a divergence factor of 6 is acceptable.

We recommend to published the datasheet in the current version.


Attached Files
.pdf   Spetech-DRYFLEX NR 800H FG APX2-4.0 mm_Cross-Check_2025-08-29.pdf (Size: 202.8 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)