Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
75.00%
6 75.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
25.00%
2 25.00%
Abstain
0%
0 0%
Total 8 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Teadit International TF1590 3.0mm
#5
(07-20-2020, 11:58 AM)AMTEC Wrote: The following cross-check is defined:

EG @ RT

In the cross-check the divergence was outside the allowable range, see document dated on 2020-09-23. Also in a second cross-check, the deviation was higher than specified in the ESAData spec.

Teadit decided to use the values of the two cross-checks for publication. With the values of these tests the datasheet was updated, see attached document dated on 2020-09-30. The information about bore intrusion was also added.

If nobody has any objections, the datasheet will be accepted.
Agree with proposal.
Reply


Messages In This Thread
Teadit International TF1590 3.0mm - by root - 01-06-2020, 12:12 AM
RE: Teadit International TF1590 3.0mm - by Donit - 06-08-2020, 02:00 PM
RE: Teadit International TF1590 3.0mm - by AMTEC - 07-20-2020, 11:58 AM
RE: Teadit International TF1590 3.0mm - by Donit - 10-01-2020, 02:56 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)