Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
75.00%
6 75.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
25.00%
2 25.00%
Abstain
0%
0 0%
Total 8 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Teadit International TF1590 3.0mm
#1
Thumbs Up 
Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 04/27/12

Material: PTFE

Link to gasketdata.org


Attached Files
.pdf   Teadit_TF1590_3mm_v1_ESA Approval_2020-05-20.pdf (Size: 109.24 KB / Downloads: 15)
Reply
#2
The data of Qsmax test at RT show that something happen at 160 MPa.
Maybe Qsmax cross-check test shall be done for RT.
I also think that bore intrusion will appear at many tests.

Maja
Reply
#3
Cross check Qsmax data at RT and at elevated temperatures.

Vinay
Reply
#4
The following cross-check is defined:

EG @ RT

In the cross-check the divergence was outside the allowable range, see document dated on 2020-09-23. Also in a second cross-check, the deviation was higher than specified in the ESAData spec.

Teadit decided to use the values of the two cross-checks for publication. With the values of these tests the datasheet was updated, see attached document dated on 2020-09-30. The information about bore intrusion was also added.

If nobody has any objections, the datasheet will be accepted.


Attached Files
.pdf   Teadit_TF1590_3mm_v1a_ESA Approval_2020-09-30.pdf (Size: 109.58 KB / Downloads: 2)
.pdf   Teadit_TF1590_3mm_v1_Cross-Check_2020-09-23.pdf (Size: 213.76 KB / Downloads: 1)
Reply
#5
(07-20-2020, 11:58 AM)AMTEC Wrote: The following cross-check is defined:

EG @ RT

In the cross-check the divergence was outside the allowable range, see document dated on 2020-09-23. Also in a second cross-check, the deviation was higher than specified in the ESAData spec.

Teadit decided to use the values of the two cross-checks for publication. With the values of these tests the datasheet was updated, see attached document dated on 2020-09-30. The information about bore intrusion was also added.

If nobody has any objections, the datasheet will be accepted.
Agree with proposal.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)