Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
75.00%
3 75.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
0%
0 0%
Abstain
25.00%
1 25.00%
Total 4 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Eynard Robin - KLINGERtop-chem3210 - 2.0 mm
#3
Cross-check EG @ RT was recommended.



In the EG test, it was recoignized that during the dwell time and even during the unloading of the gasket creep occured. This behavior led to unrealistic steep (or even negative) slopes of the unlaoding curves, see attached document. We evaluated therefore an area in which the recovery was no longer superimposed by creep.




With this evaluation, the divergence at low gasket stresses was higher than the acceptable one. In the repetition of the cross-check, the results of the first cross-check was confirmed. Eynard Robin agreed to the replacement of their EG/RT results against the results of the two cross-checks.




The results of the cross-checks are attached. The revised datasheet is uploaded in the first post of this thread, it can be accepted in the present form


Attached Files
.pdf   Discussion Creep during Compression Test.pdf (Size: 759.95 KB / Downloads: 1)
.pdf   Eynard Robin-KLINGERtop-chem3210 - 2.0 mm_Cross-Check_2022-04-12.pdf (Size: 108.17 KB / Downloads: 1)
Reply


Messages In This Thread
RE: Eynard Robin - KLINGERtop-chem3210 - 2.0 mm - by AMTEC - 05-20-2022, 06:24 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)