Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
0%
0 0%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
100.00%
7 100.00%
Abstain
0%
0 0%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flexitallic Sigma 500 2.0 mm
#6
Agree with AMTEC, however the surrounding values are very close, so it is either the material, or the rig.
Perhaps a cross-check will give the same results. Just speculating
Reply


Messages In This Thread
Flexitallic Sigma 500 2.0 mm - by AMTEC - 06-20-2024, 11:07 AM
RE: Flexitallic Sigma 500 2.0 mm - by Donit - 06-20-2024, 01:04 PM
RE: Flexitallic Sigma 500 2.0 mm - by Montero - 06-21-2024, 11:06 AM
RE: Flexitallic Sigma 500 2.0 mm - by SGL - 06-21-2024, 11:57 AM
RE: Flexitallic Sigma 500 2.0 mm - by Klinger - 06-26-2024, 09:21 PM
RE: Flexitallic Sigma 500 2.0 mm - by AVKO - 06-27-2024, 05:28 PM
RE: Flexitallic Sigma 500 2.0 mm - by Teadit - 06-28-2024, 09:32 AM
RE: Flexitallic Sigma 500 2.0 mm - by AMTEC - 07-15-2024, 01:07 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)