Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
28.57%
2 28.57%
No (Comment in the thread)
28.57%
2 28.57%
Yes, but cross-check is required (Specify kind of test in the thread)
28.57%
2 28.57%
Abstain
14.29%
1 14.29%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm
#1
Thumbs Up 
Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 14.01.2013

Material: GR

Link to gasketdata.org


Attached Files
.pdf   Frenzelit novaphit SSTC TA-L with XP 2,0 mm_ESA Approval_2020-10-03.pdf (Size: 205.17 KB / Downloads: 21)
.pdf   Frenzelit novaphit SSTC TA-L with XP 2,0 mm_ESA Approval_a_2020-11-09.pdf (Size: 669.61 KB / Downloads: 8)
Reply
#2
According to our measurements leakage is far too optimistic. I vote for a leakage cross-check at 40 bar.
Reply
#3
I think thatĀ that Pqr values must be providedĀ at 3 different gasket surface stresses.
If you disagree, skeep my vote.
Reply
#4
Standard requires 3 Pqr values at each temperature
Reply
#5
Agree for three gasket loads at each temperature
Reply
#6
Since it is a direct import from munster data, not sure if the 3 x stress level rule should applies.
Reply
#7
add PQR values at 3 different temperatures
Reply
#8
A cross-check (leakage test) at 40 bar was requested. The result oof the cross-check and comparison with the submitted data is attached in this post. The characteristics provided by Frenzelit are conservative, and therefore accepted.

In addition, Frenzelit provided the missing data for the creep relaxation tests. The results fit to the other characteristics sent earlier.

Therefore, we suggest that the datasheet can be accepted now.

The datasheet is updated and available in the first post of this thread.


Attached Files
.pdf   Frenzelit novaphit SSTC TA-L with XP 2,0 mm_Cross-check.pdf (Size: 51.42 KB / Downloads: 2)
Reply
#9
Agreed.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)