Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
100.00%
4 100.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
0%
0 0%
Abstain
0%
0 0%
Total 4 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SGL SIGRAFLEX HOCHDRUCK PRO V20011Z3IP 2.0 mm
#1
Thumbs Up 
Update of Datasheet

Results of compression and creep relaxation tests 
at 550 °C were added. The characteristics at this temperature level fit to the ones determined at lower temperature levels, therefore we don not think that a cross-check is necessary.

Type: Sheet Gasket
Material: Graphite
Publication of last revision: 14.06.2022


Attached Files
.pdf   SGL-SIGRAFLEX HOCHDRUCK PRO-V20011Z3IP-2.0 mm_ESA Approval Rev03_2023-05-23.pdf (Size: 505.25 KB / Downloads: 5)
Reply
#2
Approved from my side.

Beside the situation, that a graphite gasket without encapsulation will not be able to withstand 550°C performance-wise, but this for sure has to be handled by the SGL team and is of no concern for the pure technical data.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)