Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
0%
0 0%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
83.33%
5 83.33%
Abstain
16.67%
1 16.67%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flexitallic Sigma 533 2.0 mm
#1
Thumbs Up 
Approval of new Datasheet



Type:         Sheet Gasket




Material:     PTFE




Cross-check: Due to the discontinuous course we recommend a EG test at RT.


Attached Files
.pdf   Flexitallic-Sigma 533-2.0mm_ESA Approval_2024-06-20.pdf (Size: 1.3 MB / Downloads: 5)
Reply
#2
Agree with amtec suggestion.

BR, Maja
Reply
#3
QSmax for 250°C is 30-50MPa higher than all other barium mgaskets on the market, questionable and needs to be checked.
Leakeage curve for 25bar needs to be renewed by flexitallic with longer holding times for mass-spectrometer in order to avoid unloading crossing the loading curve re-test with longer holding time will show fair result.

PQR looks good for all temperatures. Qsmax seems to be 20MPa higher than most other barium modified gaskets on the market, but this seems to be in line across temperatures.
Reply
#4
Agree with AMTEC
Reply
#5
Agree with check on Qsmax f@ 250°C.
Reply
#6
As I mentioned earlier, 260°C is the limit for this product - pretty sure it has some reserve, however we can expect all kind of discrepancies at 250°C.
A X-check will not hurt done with EG test at R.T.
Reply
#7
Cross-check:

QSmax @ 250°C

The EG values at all stress levels at 250 °C in the cross-check were within the allowable divergence compared to the values which were submitted by the manufacturer.

Therefore, we recommend to publish the characteristics of this material.


Attached Files
.pdf   Flexitallic-Sigma 533-2.0mm_Cross-Check_2024-07-23.pdf (Size: 150.96 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)