Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
28.57%
2 28.57%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
57.14%
4 57.14%
Abstain
14.29%
1 14.29%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IDT SD10 WS 1.4541-Graphit-St37-10-25-40-80-160
#1
Thumbs Up 
Approval of a new data sheet


Type: spiralwound gasket

Material: GR

Testing lab: In-House


Attached Files
.pdf   IDT_SD10 WS 1.4541-Graphit-St37-10-25-40-80-160 bar_ESA Approval_2020-10-01.pdf (Size: 206.08 KB / Downloads: 10)
Reply
#2
Will abstain because I do not know how to vote. Like to add my comments. 1. agree with amtec on eg at 400degC and 2. PQR has a big tolerance (not too big) and at 500degC PQR is higher for 30-130MPa compared to lower temperature, which looks for me strange. Is the 500degC test done on another test rig? standard rig is limited to 400degC.
Reply
#3
As it is a new data sheet, a cross check needs to be performed. For me PQR at 30 MPa at 500°C is most surprising, therefore I would vote for this test.
Reply
#4
(10-02-2020, 09:53 AM)SGL Wrote: As it is a new data sheet, a cross check needs to be performed. For me PQR at 30 MPa at 500°C is most surprising, therefore I would vote for this test.
Agree with this proposal.
Leakage test at 160 bar is also a bit 'strange'.
Reply
#5
Results of PQR at 500°C obviously doesn't fit. Cross check especially for PQR 30 MPa 500°C required
Reply
#6
Cross check PQR @ 500 C at stresses 30, 50, 130, 200 MPa.
Reply
#7
Cross-check: PQR @ 30 MPa/500 °C

The PQR value determined in the cross-check is significant lower than the published value (0.75 vs. 0.87). In the repetition of the cross-check, the first was confirmed (0.75). IDT agreed to change PQR @ 30 MPa/500 °C to 0.75. In this case, all PQR appear consistent.

The new value will be used in the final datasheet, it can be accepted now.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)